Output Shaft (Countershaft) Speed Sensor Replacement
- Remove the splash shield.
- Disconnect the output shaft (countershaft) speed sensor connector, and remove the output shaft (countershaft) speed sensor (A) and washer (B).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Install a new O-ring (C) on a new output shaft (countershaft) speed sensor, then install the output shaft (countershaft) speed sensor and the washer in the transmission housing.
- Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
- Install the splash shield.