DTC B1052: Relay Control Module Internal (EEPROM Error) Error
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see
TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0), and then back to ON (II).
- Check for DTCs with the HDS.
Is DTC B1052 indicated?
YES -Replace the relay control module (see REMOVAL AND INSTALLATION ).
NO -Intermittent failure, the system is OK at this time.