DTC B1060: Relay Control Module Lost Communication With Gauge Control Module (VPS/NE Message); DTC B1061: Relay Control Module Lost Communication With Gauge Control Module (A/T Message)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Wait for at least 6 seconds.
- Check for DTCs with the HDS.
Are DTCs B1060 and/or B1061 indicated?
YES -Go to step 5.
NO -Intermittent failure, the system is OK at this time. Check for loose or poor connection. ■
- Check for DTCs with the HDS.
B1060: Are DTCs B1011 and B1205 also indicated? B1061: Is DTC B1008 also indicated?
YES -Do the gauge control module input test (see GAUGE CONTROL MODULE INPUT TEST ). ■
NO -Do the relay control module input test (see RELAY CONTROL MODULE INPUT TEST ). ■