Driving Position Memory Switch Test/Replacement
- Remove the driver's door panel (see
FRONT DOOR PANEL REMOVAL/INSTALLATION
).
- Disconnect the 7P connector (A) from the driver's position memory switch (B).
Courtesy of ABLE BODY CORP.
- Remove the four screws, then remove the switch from the door panel.
- Check for continuity between the terminals in each switch position according to the table.
NOTE:
- Make sure the correct test lead (+ or -) is placed on the terminal.
- When checking for continuity across the diode, use the diode setting (→(symbol)) on the digital volt/ohm meter to check the diode bias.
- Note this important operating characteristic: diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
Courtesy of ABLE BODY CORP.
- If the continuity is not as specified, replace the switch.
- Install the switch in the reverse order of removal.