Rearview Camera Removal/Installation

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.

Remove the tailgate lower trim panel (see TRIM REMOVAL/INSTALLATION - TAILGATE AREA ).
Disconnect the rearview camera 6P connector and the licence plate light sub harness 4P connector (A).

Fig 1: Identifying Licence Plate Light Sub Harness 4P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the nuts (A) and release the clips (B). Pull the rear license trim (C) away from the tailgate, then remove the grommet (D) from the tailgate and carefully pull the connector through the hole in the tailgate.

Fig 2: Identifying Nuts, Clips, Rear License Trim & Grommet
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the connectors and detach the harness clip (A) from the rear license trim.

Fig 3: Identifying Harness Clip & Rearview Camera
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws and rearview camera (B).
Install the rearview camera in the reverse order of removal.