LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2015 >> Pilot SE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Navigation System) >> System Description >> Rearview Camera Inputs and Outputs
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rearview Camera Inputs and Outputs

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Rearview Camera 4P Connector Terminals
G05969077Courtesy of AMERICAN HONDA MOTOR CO., INC.

Rearview Camera 4P Connector 

VOLTAGE SPECIFICATION

Terminal Number Wire Color Terminal Name Description Voltage (about) Symptom
1 RED CAMERA VCC (VCC supply) Power source for rearview camera 8V If open: No rearview camera image.
If short to ground: When put into reverse, navigation screen goes black (display backlight still operative).
2 BLK CAMERA ADPT (Adaptive camera) Control signal for rearview camera 0 V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
3 WHT CAMERA VIDEO (Video camera) Video signal for rearview camera 0.3V If open: No rearview camera image.
If short to ground: When put into reverse, navigation screen goes black (display backlight still operative).
4 GRN(1) CAMERA SH (Shield camera) Shield for terminals No. 1, 2, 3 0 V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
(1) The shielded wires have a heat-shrink tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire shown on the circuit diagram.