Calibration Completion Check

Check if calibration is completed by doing the following:

1. Stop the vehicle and shift into neutral (N).
2. Turn the vehicle to the OFF (LOCK) mode.
3. Turn the ignition switch to ON mode and wait to see the low pressure indicator come on for 2 seconds and then off.
4. Do not drive the vehicle and wait for 45 seconds as is.
5. If the calibration is completed, the indicator does not come on. If the calibration is not yet completed, then the indicator will come on for 2 seconds and then go off.
   NOTE: The calibration check process gets interrupted if the vehicle moves. Do the troubleshooting if the indicator does not go off after 2 seconds, keeps blinking or stays on when the vehicle is in the ON mode.