DTC C0063-F0

DTC C0063-F0: Yaw Rate Sensor Malfunction

NOTE:

Initial Diagnosis:
The initial on-board diagnosis occurs right after the vehicle condition is turned to the ON mode, and the ABS/VSA indicator comes on, and continues until the indicator goes off.
Regular Diagnosis:
The regular on-board diagnosis begins right after the ABS/VSA indicator goes off, and it continues until the vehicle condition is turned to the OFF (LOCK) mode.
Review "How to troubleshoot the VSA system" before doing the DTC troubleshooting procedure.
Test-drive the vehicle according to local traffic conditions and regulations. Do not test-drive on a lift unless specified.
The possible causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.

Confirmation Procedure	Operating Condition: Turn the vehicle to the READY TO DRIVE mode. Test-drive the vehicle at 31 mph (50 km/h) or more for 10 seconds. Turn the steering wheel stable to left. Turn the steering wheel stable to right. (Drive the vehicle on the road, not on a lift. Be careful of the surrounding traffic conditions.)
Execution	Initial Diagnosis/Regular Diagnosis
Duration	About 1 second
DTC Type	1 drive cycle VSA indicator on
Fail Safe Action	Stop TCS function Stop VSA function Stop engine drag torque control function Stop agile handling assist function
Possible Cause	SRS unit internal failure