LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 414 (Seat System) >> Repair Instructions >> Memory Seat Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the module into the vehicle.
  2. Connect the lower electrical harness connectors (2).
  3. Slide the module (2) to the left to engage the lower retainers.
    4. Fig 1: Connecting Lower Electrical Harness Connectors
    GM914892Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the module retaining screws (3).

    Tighten:  Tighten the screws to 3 N.m (26 lb in).

  5. Connect the upper electrical harness connectors (3).
    6. Fig 2: Memory Seat Control Module, Harness Connectors & Screws
    GM914889Courtesy of GENERAL MOTORS CORP.
  6. Install the seat cushion. Refer to Seat Cushion Frame Replacement - Front .
  7. If a new memory seat module was installed, calibrate the seat. Refer to Memory Seat Calibration Procedure .
scientia non olet · About LEMON Manuals