LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 582 (Seat System) >> Repair Instructions >> Memory Seat Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lower Electrical Harness Connectors & Memory Seat Control Module
    GM914892Courtesy of GENERAL MOTORS CORP.
  1. Position the module into the vehicle.
  2. Connect the lower electrical harness connectors (2).
    3. Fig 2: Memory Seat Control Module
    GM914889Courtesy of GENERAL MOTORS CORP.
  3. Slide the module (2) to the left to engage the lower retainers.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the module retaining screws (3).

    Tighten:  Tighten the screws to 3 N.m (26 lb in).

  5. Connect the upper electrical harness connectors (3).
  6. Install the seat cushion. Refer to Seat Cushion Frame Replacement - Front .
  7. If a new memory seat module was installed, calibrate the seat. Refer to Memory Seat Calibration Procedure .
scientia non olet · About LEMON Manuals