Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Blower Motor Control Processor & HVAC Module Assembly

Courtesy of GENERAL MOTORS CORP.

Install the blower motor control processor (3) to the HVAC module assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws to the blower motor control processor (3).
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
Connect the electrical connector (4) to the blower motor control processor (3).
Connect the electrical connector (2) to the blower motor (1).
Install the I/P insulator panel. Refer to Insulator Replacement - Instrument Panel (I/P) .