Installation Procedure

Fig 1: Positive Cable Nut

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the positive cable nut (1).
Tighten: Tighten the nut to 9 N.m (80 lb in).

Fig 2: View Of Positive Battery Cable, Channel & Bolt

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable to the channel.
Slide the channel pin into the oil pan tab.
Install the positive battery cable channel bolt.
Tighten: Tighten the bolt to 12 N.m (106 lb in).
Install the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
Lower the vehicle.

Fig 3: View Of Battery Cables At Junction Block

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable (1) into the junction block.
Tighten: Tighten the nut to 9 N.m (80 lb in).
Snap the junction block cover closed.

Fig 4: Positive Battery Cable Bolt

Courtesy of GENERAL MOTORS CORP.

Tighten the positive cable bolt at the UBEC.
Tighten: Tighten the bolt to 9 N.m (80 lb in).
Position the UBEC lower cover.
Install the UBEC cover.

Fig 5: View Of Negative Battery Cable At Battery

Courtesy of GENERAL MOTORS CORP.

Connect the positive battery cable.
Tighten: Tighten the bolt to 17 N.m (13 lb ft).
Snap the positive battery cable cap closed.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) .