LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2004 >> H2 4D Utility Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 712 (Sir) >> Repair Instructions >> Inflatable Restraint Steering Wheel Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2003 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electrical Connectors & Inflatable Restraint Steering Wheel Module
    GM760456Courtesy of GENERAL MOTORS CORP.
  1. Position the inflatable restraint module to the steering wheel.
  2. Connect the electrical connectors (1) to the inflatable restraint steering wheel module.
  3. Connect the CPA retainers into the electrical connectors. Seat and lock the connections.
    4. Fig 2: Removing/Installing Leaf Spring Fasteners
    GM760459Courtesy of GENERAL MOTORS CORP.
  4. Position the alignment posts of the inflatable restraint module to the holes that are located on the steering wheel housing.
  5. Push the inflatable restraint module into the steering wheel in order to engage and in order to latch the 2 leaf spring fasteners (1).
  6. After installation, pull the sides of the inflatable restraint module in order to ensure that both leaf spring fasteners are engaged.
  7. Enable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling Zone 3 .
scientia non olet · About LEMON Manuals