LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2006 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Body & Frame >> Seats >> Repair Instructions >> Front Seat Back Frame Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Position the seat back frame on the seat.
    2. Fig 1: Front Seat Frame
    GM386187Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the recliner arm attachment bolts (2).

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft).

  3. Install the inboard pivot bolt (1).

    Tighten:  Tighten the bolt to 35 N.m (26 lb ft).

  4. Install the seat belt retractor. Refer to Seat Belt Retractor Replacement - Left Front or Seat Belt Retractor Replacement - Right Front .
  5. Install the lumbar assembly or power lumbar/bolster assembly if equipped. Refer to Front Seat Lumbar Support Replacement .
  6. Install the seat back trim cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement .
    7. Fig 2: View Of Lumbar Cable And Front Seat Cushion Frame Components
    GM407184Courtesy of GENERAL MOTORS CORP.
  7. Connect the lumbar cable (6) underneath the seat cushion. Disconnect the wire harness if equipped with power lumbar.
  8. Install the seat trim panel. Refer to Front Seat Trim Panel Replacement .
  9. Install the head restraint and guides. Refer to Head Restraint Replacement .
  10. Install the seat into the vehicle. Refer to Front Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals