LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2006 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Instrument Panel Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of PSIR Bracket
    GM1284589Courtesy of GENERAL MOTORS CORP.
  1. If replacing the PSIR bracket, install the PSIR bracket to the I/P structure.
  2. Fig 2: View Of PSIR Bracket To I/P Structure Fasteners
    GM1284588Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 2 fasteners retaining the PSIR bracket to the I/P structure.

    Tighten:  Tighten the fasteners to 9 N.m (80 lb in).

  4. Install the I/P assembly. Refer to Instrument Panel (I/P) Assembly Replacement in Instrument Panel, Gages, and Console.
  5. Fig 3: View Of PSIR Module
    GM1276395Courtesy of GENERAL MOTORS CORP.
  6. Position the PSIR inflator module to the front of the I/P and connect the electrical connector.
  7. Connect the CPA.
  8. Install the PSIR inflator module to the I/P.
  9. Fig 4: View Of PSIR Inflator Module Fasteners
    GM1304351Courtesy of GENERAL MOTORS CORP.
  10. Partially Install the 2 lower fasteners retaining the PSIR module to the I/P structure.
  11. Fig 5: View Of PSIR Module Retaining Nuts
    GM1304254Courtesy of GENERAL MOTORS CORP.
  12. Install the 2 side retaining nuts (1) to the PSIR inflator module.

    Tighten:  Tighten the 4 PSIR fasteners until fully driven, seated and not stripped.

  13. Install the digital radio receiver, if equipped. Refer to Receiver Replacement - Digital Radio in Entertainment.
  14. Install the radio. Refer to Radio Replacement in Entertainment.
  15. Install the I/P accessory trim panel. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory in instrument Panel, Gages, and Console.
  16. Install the right air outlet. Refer to Air Outlet Replacement - Instrument Panel - Right in Heating, Ventilation, and Air Conditioning.
  17. Install the right access cover to the I/P end cap.
  18. Enable the SIR System. Refer to SIR Disabling and Enabling Zone 5 .
  19. Install the I/P compartment door. Refer to Door Replacement - Instrument Panel (I/P) Compartment in Instrument Panel, Gages, and Console.