LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 6.0L - Introduction (2 Of 2) >> Repair Instructions >> Powertrain Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
    2. Fig 1: PCM Cover
    GM863123Courtesy of GENERAL MOTORS CORP.
  2. Release the PCM cover mounting holes away from the mounting tabs on the PCM mounting bracket.
  3. Release the PCM cover from the mounting bracket.
  4. Remove the PCM cover.
    5. Fig 2: PCM Harness Connectors
    GM863125Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not touch the connector pins or soldered components on the circuit board in order to prevent possible electrostatic discharge (ESD) damage to the PCM.
    NOTE: In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.
  5. Loosen both PCM connector retaining bolts.
  6. Disconnect the PCM harness connectors.
  7. Release the spring latch from the PCM.
  8. Release the PCM mounting tabs from the PCM.
    9. Fig 3: PCM & Engine Compartment
    GM863127Courtesy of GENERAL MOTORS CORP.
  9. Remove the PCM from the engine compartment.
scientia non olet · About LEMON Manuals