Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Radio Antenna Cable & Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Position the radio to the I/P.
Connect the electrical connectors to the radio.
Connect the radio antenna cable to the radio.
Position the radio rear alignment locator into the I/P substrate installing the radio to the I/P.

Fig 2: View Of Radio & Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 3 screws that retain the radio to the I/P.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory in Instrument Panel, Gages and Console.