Scan Tool Output Controls

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Scan Tool Output Control	Additional Menu Selections	Description
Refer to the scan tool manual for complete scan tool operating instructions.
ABS Motor	-	This function allows the technician to command the ABS pump motor On and Off.
Solenoid Tests	Left Front Isolation Valve Left Front Dump Valve Right Front Isolation Valve Right Front Dump Valve Rear Isolation Valve Rear Dump Valve	This function allows the technician to command a selected valve solenoid On and Off. Use the procedures below to verify proper operation of the EBCM and BPMV. Dump Valve Solenoid Test Procedure Apply the parking brake fully. Start the engine and allow the engine to idle. Select the desired Dump Valve Solenoid Test on the scan tool. Apply the brake and maintain steady pressure on the brake pedal. Command the solenoid On and verify that the brake pedal drops to the floor. Isolation Valve Solenoid Test Procedure Apply the parking brake fully. Start the engine and allow the engine to idle. Select the desired Isolation Valve Solenoid Test on the scan tool. Apply the brake with very light pressure only enough to close the brake switch. Command the solenoid On and then immediately apply firm and steady pressure to the brake pedal. The EBCM automatically de-energizes the solenoid after about 3 seconds. When this occurs, verify that the brake pedal drops about 2.2 cm (1 inch).

Scan Tool Output Control

Additional Menu Selections

Description

Refer to the scan tool manual for complete scan tool operating instructions.

ABS Motor

This function allows the technician to command the ABS pump motor On and Off.

Solenoid Tests

Left Front Isolation Valve
Left Front Dump Valve
Right Front Isolation Valve
Right Front Dump Valve
Rear Isolation Valve
Rear Dump Valve

This function allows the technician to command a selected valve solenoid On and Off. Use the procedures below to verify proper operation of the EBCM and BPMV.

Dump Valve Solenoid Test Procedure

Apply the parking brake fully.
Start the engine and allow the engine to idle.
Select the desired Dump Valve Solenoid Test on the scan tool.
Apply the brake and maintain steady pressure on the brake pedal.
Command the solenoid On and verify that the brake pedal drops to the floor.

Isolation Valve Solenoid Test Procedure

Apply the parking brake fully.
Start the engine and allow the engine to idle.
Select the desired Isolation Valve Solenoid Test on the scan tool.
Apply the brake with very light pressure only enough to close the brake switch.
Command the solenoid On and then immediately apply firm and steady pressure to the brake pedal.
The EBCM automatically de-energizes the solenoid after about 3 seconds. When this occurs, verify that the brake pedal drops about 2.2 cm (1 inch).