Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Headlamp Switch

Courtesy of GENERAL MOTORS CORP.

Position the switch to the I/P.
Connect the electrical connector to the switch.
Install the switch to the I/P.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screw retaining the switch to the I/P.
Tighten: Tighten the screw to 2.5 N.m (22 lb in).
Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster in Instrument Panel, Gages and Console.