LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2007 >> H3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Control System - 2.8L (LK5) - Introduction) >> Repair Instructions >> Accelerator Pedal Position (APP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of APP Sensor
    GM1352013Courtesy of GENERAL MOTORS CORP.
  1. Position the APP sensor over the studs.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the APP sensor nuts.

    Tighten:  Tighten the APP sensor mounting nuts to 9 N.m (80 lb in).

  3. Connect the APP sensor electrical connector.
  4. Inspect below the pedal for binding, to ensure full range of motion.
scientia non olet · About LEMON Manuals