LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 6.2L - Introduction (2 Of 2) >> Repair Instructions >> Engine Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
    2. Fig 1: PCM Cover
    GM863123Courtesy of GENERAL MOTORS CORP.
  2. Release the ECM cover mounting holes away from the mounting tabs on the ECM mounting bracket.
  3. Release the ECM cover from the mounting bracket.
  4. Remove the ECM cover.
    5. Fig 2: PCM Harness Connectors
    GM863125Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to PCM and ESD Notice.
    NOTE: In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.
  5. Loosen both ECM connector retaining bolts.
  6. Disconnect the ECM harness connectors.
  7. Release the spring latch from the ECM.
  8. Release the ECM mounting tabs from the ECM.
    9. Fig 3: PCM & Engine Compartment
    GM863127Courtesy of GENERAL MOTORS CORP.
  9. Remove the ECM from the engine compartment.
scientia non olet · About LEMON Manuals