Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Digital Radio Receiver & Wire Connector

Courtesy of GENERAL MOTORS CORP.

Connect the coaxial cables.
Connect the electrical connector (1).
Install the receiver and bracket assembly to the I/P.

NOTE: Refer to Fastener Notice .

Install the 2 screws.
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
Install the right side junction block to the I/P. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Right Side .
Close the I/P compartment door.
Perform the setup procedure for the digital radio receiver. Refer to Control Module References for programming and setup information.