LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Steering Linkage >> Repair Instructions >> Relay Rod Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Place the relay rod to the vehicle.
    2. Fig 1: Seating Idler Arm Tapers
    GM689037Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Use installer J 29193  or installer J 29194  to seat the idler arm and pitman arm to the relay rod. See Special Tools .

    Tighten:  Tighten the installer to 54 N.m (40 lb ft).

    3. Fig 2: View Of Idler Arm
    GM793272Courtesy of GENERAL MOTORS CORP.
  3. Install the new pitman arm nut.

    Tighten:  Tighten the nut to 60 N.m (44 lb ft).

  4. Install the new idler arm nut.

    Tighten:  Tighten the nut to 60 N.m (44 lb ft).

  5. Connect the steering linkage outer tie rods to the steering knuckles. Refer to Steering Linkage Outer Tie Rod Replacement .
  6. Install the steering linkage shock absorber. Refer to Steering Linkage Shock Absorber Replacement .
  7. Adjust the front toe. Refer to Front Toe Adjustment .
scientia non olet · About LEMON Manuals