LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Steering Linkage >> Repair Instructions >> Relay Rod Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Remove the steering linkage shock absorber. Refer to Steering Linkage Shock Absorber Replacement .
  2. Disconnect the steering linkage outer tie rods from the steering knuckles. Refer to Steering Linkage Outer Tie Rod Replacement .
    3. Fig 1: Idler Arm Ball Stud Nut
    GM793270Courtesy of GENERAL MOTORS CORP.
  3. Remove the pitman arm nut and discard it.
    4. Fig 2: View Of Idler Arm
    GM793272Courtesy of GENERAL MOTORS CORP.
  4. Remove the idler arm nut and discard it.
  5. Separate the relay rod from the pitman arm and idler arm using puller J 24319-B  .
  6. Remove the relay rod from the vehicle.
  7. Inspect for any damage on the steering linkage components and repair or replace as needed.
  8. Clean all threads on the steering linkage components.
scientia non olet · About LEMON Manuals