Vehicle Stability Control Module Scan Tool Information
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Vehicle Stability Control Module Scan Tool Data Parameters
| Parameter | System State | Expected Value | Description |
|---|---|---|---|
| Operating Conditions: Ignition ON | |||
| Accel. Sen. Lateral 1 Signal | - | Varies | This displays °. |
| Accel. Sen. Lateral 2 Signal | - | Varies | This displays °. |
| Accel. Sen. Yaw 1 Signal | - | Varies | This displays °/sec. |
| Accel. Sen. Yaw 2 Signal | - | Varies | This displays °/sec. |
| Accel. Sensor Longitudinal Signal | - | 0 m/s2 | This displays m/s2 . |
| Battery Voltage Signal | - | Varies | This displays Volts. This is the current battery voltage signal. |
| Steering Position Sensor Signal | - | Varies | This displays °. This is the current degree position of the steering position sensor. |
| Steering Position Sensor Status | - | Centered | The scan tool displays Centered or Uncentered. This is the current status of the steering position sensor. |
Vehicle Stability Control Module Scan Tool Output Controls
| Output Control | Description |
|---|---|
| Acceleration Sensor Reset | This output control is used to reset the acceleration sensor. |
| Steering Position Sensor Centering | This output control is used to center the steering position sensor. |
| VSCM Power Steering Reset | This output control is used to reset the vehicle stability control module (VSCM) power steering. |