Remote Control Door Lock Receiver
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
If the remote control door lock receiver (RCDLR) is replaced, the following procedures must be performed in the order listed below:
- Perform the Keyless Entry Transmitter Programming procedure. Refer to Transmitter Programming (N. America and Japan, except Canada) or Transmitter Programming (Canada and Japan) , using Method 2 to perform the programming.
- Perform the procedure to set up a new RCLDR:
- Connect the Tech 2 to the vehicle.
- Select RCDLR under Module Setup in the Vehicle Control System menu.
- Select Setup New RCDLR.
- Follow the on-screen instructions.
- Perform the 10-Minute Immobilizer Relearn procedure for the SCLM. Refer to Immobilizer System Component Programming
.
During the SCLM programming, select Theft Deterrent Learn for Column Lock Module (Export Only) on the SPS terminal.
- Perform the 10-Minute Immobilizer Relearn procedure for the ECM. Refer to Immobilizer System Component Programming
.
When performing the relearn procedure, select Theft Deterrent Learn for ECM (Export Only) on the SPS terminal.
- Perform the Tire Pressure Sensor Learn procedure. Refer to Tire Pressure Sensor Learn .
IMPORTANT:
The 10-Minute Immobilizer Relearn procedure for the SCLM must be done first. Failure to do so may result in complications when attempting to perform the 10-Minute Immobilizer Relearn procedure for the ECM.