Installation Procedure
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- When replacing the VCIM, record the 11-digit ESN and the 10-digit STID number from the label on the new VCIM.
- When replacing the VCIM, be sure to transfer the Bluetooth Antenna, if equipped.
- Reconnect the electrical connectors the module.
- Install the module onto the vehicle and tighten the nuts to 9 N.m (80 lb in).
- The default language for the new VCIM is English. Refer to the Module Setup screen if the customer requests French or Spanish Voice Recognition.
- Refer to Control Module References for programming and set up information.
CAUTION:
Refer to Fastener Caution
.
NOTE:
After replacing the vehicle communication interface module, you must reconfigure the OnStar® system. Failure to reconfigure the system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this version of the OnStar® system. This action will cause a DTC to set.