LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Alpha >> Repair and Diagnosis >> External Pages >> Different car >> Section 532 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: BPMV & EBCM
    GM1906543Courtesy of GENERAL MOTORS CORP.
  1. Clean the sealing surfaces of the BPMV and the EBCM.
  2. Install the EBCM (1) to the BPMV.
    3. Fig 2: EBCM & Screws
    GM1906542Courtesy of GENERAL MOTORS CORP.
  3. Install the EBCM screws (1).
    4. Fig 3: Identifying EBCM Screw Tightening Sequence
    GM782378Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  4. Tighten the EBCM screws in the sequence shown (1-4) to 3 N.m (26 lb in).
  5. Connect the EBCM electrical connector.
  6. Position the washer solvent container and install the fasteners. Refer to Windshield Washer Solvent Container Replacement (Without CE4) or Windshield Washer Solvent Container Replacement (With CE4) .
  7. Install the front air deflector shield. Refer to Front Air Deflector Replacement .
  8. Lower the vehicle.
  9. If installing a new EBCM, program the EBCM. Refer to Control Module References .
  10. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals