Removal Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Vehicle Stability Control Module Bracket Locking Tabs

Courtesy of GENERAL MOTORS CORP.

Turn the ignition switch to the OFF position.
Remove the left rear compartment side trim panel. Refer to Rear Compartment Trim Panel Replacement .
Disconnect the stability control module electrical connectors.
Release the stability control module from the module bracket locking tabs (1).

Fig 2: Stability Control Module

Courtesy of GENERAL MOTORS CORP.

Lift the stability control module (1) from the bracket and remove the stability control module.

Fig 3: Stability Control Module Bracket & Nuts

Courtesy of GENERAL MOTORS CORP.

If necessary, remove the stability control module bracket nuts (1) and remove the bracket.