LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
    2. Fig 1: View Of Inflatable Restraint Side Impact Sensor
    GM1348287Courtesy of GENERAL MOTORS CORP.
  2. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Peel the rear half of the water deflector away from the door in order to access the side impact sensor.
  4. Remove the screws that retain the side impact sensor to the door.
  5. Disconnect the impact sensor electrical connector from the side impact sensor.
  6. Remove the side impact sensor from the door.
scientia non olet · About LEMON Manuals