Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Brake Pedal Position Switch

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector on the switch.
Align the brake panel position switch to the stud (3).

NOTE: Refer to Fastener Notice .

Install the bolt (1) securing the brake panel position switch to the brake panel bracket.
Tighten: Tighten the bolt (1) to 9 N.m (80 lb in).
Install the driver side I/P insulator closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
Recalibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .