LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 183 (Front Suspension System) >> Repair Instructions >> Shock Module Yoke Replacement (AWD) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Yoke
    GM874641Courtesy of GENERAL MOTORS CORP.
  1. Install the yoke to the vehicle.
    2. IMPORTANT: Do not tighten the nut at this time.
    Fig 2: View Of Yoke-To-Lower Control Arm Retaining Nut
    GM874633Courtesy of GENERAL MOTORS CORP.
  2. Install the yoke to lower control arm retaining nut.
    3. Fig 3: View Of Shock-To-Yoke Retaining Bolt
    GM1209258Courtesy of GENERAL MOTORS CORP.
  3. Install the yoke to the shock.
    4. NOTE: Refer to Fastener Notice .
  4. Install the yoke to shock retaining bolt and nut.

    Tighten: 

    • Tighten the shock to yoke nut to 90 N.m (66 lb ft).
    • Tighten the yoke to lower control arm nut to 180 N.m (133 lb ft).

  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals