LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Anti-Lock Brake System, Traction Control System & Stability Control System) >> Repair Instructions >> Brake Fluid Pressure Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the ignition switch into OFF position.
  2. Remove the RH front compartment sight shield. Refer to Front Compartment Sight Shields Replacement .
  3. Thoroughly clean the area around the brake pressure modulator (BPMV) of all dirt and debris.
    4. Fig 1: View Of Brake Fluid Pressure Sensor Electrical Connector
    GM1906574Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the brake fluid pressure sensor electrical connector.
  5. Remove the brake fluid pressure sensor (1).
scientia non olet · About LEMON Manuals