LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Suspension Control System - Automatic Level Control) >> Diagnostic Information and Procedures >> Automatic Level Control System Leak Test >> Tools Required
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Tools Required

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

J 22124-B  Pressure Gage (0-300 psi)

  1. Disconnect the air tube from the air dryer.
  2. Attach the air tube to the J 22124-B  pressure gage on the side opposite the toggle valve.
  3. Close the toggle valve.
  4. Apply service air pressure to the service valve and pressurize until the J 22124-B  pressure gage reads 550 kPa (80 psi).
  5. Verify that the system maintains pressure for at least 1 minute.
    • If the system does not maintain the specified pressure for the specified amount of time, check the shock absorber air sleeves, air tubes, and all connections for air leaks using a soapy water solution. Repair or replace any leaking components. Refer to Air Tube Replacement  and Shock Absorber Replacement .
scientia non olet · About LEMON Manuals