Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Placing Locker Slider

Courtesy of GENERAL MOTORS CORP.

Place the locker slide, with the front to the outside, and slide it rearward.

Fig 2: Removing/Installing Locker Slider

Courtesy of GENERAL MOTORS CORP.

Slide the locker slider forward.
Push the pin (1) of the lever (2) carefully through the track (3) in the locker slide.

Fig 3: Sliding Lever toghether with Locker Slide

Courtesy of GENERAL MOTORS CORP.

Slide the lever together with the locker slide rearward, and rotate the lever rearward.

Fig 4: Mounting Driving Slide to Lever and Tumbler

Courtesy of GENERAL MOTORS CORP.

Mount the driving slide (1) to the lever and the front tumbler.

Fig 5: Positioning Front Tumbler

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do Not force the guides to the sliders. Use care.

Position the front tumbler and the driving slide in-line with each other.
Slide the guide carefully over the front tumbler and driving slider extends 4.5 cm (2 in) out of the guide.

Fig 6: Mounting Drive Cable on Driving Side

Courtesy of GENERAL MOTORS CORP.

Mount the drive cable on the driving slide.
Rotate the drive cable, so that the points of the oval cable end fit into the guides.

Fig 7: Sliding Guides Rearwards into Place

Courtesy of GENERAL MOTORS CORP.

Slide the guides rearwards until the end of the driving slide is 1 cm (3/8 in) within the guide.
Install the sunroof module upper frame. Refer to Sunroof Frame Replacement - Upper .
Verify the operation of the sunroof.
Close the sunshade.