Installation Procedure
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove any dirt, grease, or other impurities from the mounting surface.
- Install the SDM horizontally to the console floor.
- Point the arrow on the SDM toward the front of the vehicle.
- Install the SDM mounting fasteners and tighten to 9 N.m (80 lb in).
- Connect the wiring harness connector to the SDM.
- Install the console. Refer to Front Floor Console Replacement .
- Install the driver and the passenger seats to the original position.
- Enable the SIR system. Refer to SIR Disabling and Enabling .
- Program the new SDM into the dash integration module (DIM).
- Refer to Control Module References for programming and setup information.
CAUTION:
Refer to Fastener Caution
.
NOTE:
The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps thoroughly to ensure that the SDM is set properly.