LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Module Replacement - Front >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Inflatable Restraint Side Impact Module Electrical Connector
    GM792283Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector (1) to the inflatable restraint side impact module.
  2. Install the CPA to the module electrical connector.
    3. Fig 2: Identifying Inflatable Restraint Side Impact Module
    GM1506506Courtesy of GENERAL MOTORS CORP.
  3. Install the inflatable restraint side impact module to the seat.
  4. Install the nuts to the inflatable restraint side impact module.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    5. Fig 3: View Of Seat Back Panel
    GM1506502Courtesy of GENERAL MOTORS CORP.
  5. Install the seat back panel. Refer to Driver Seat and Passenger Seat Back Cushion Finish Panel Replacement .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
  7. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
scientia non olet · About LEMON Manuals