LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Disc Brake System) >> Repair Instructions >> Front Brake Caliper Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Caliper Guide Pin Bolts
    GM891307Courtesy of GENERAL MOTORS CORP.
  1. Install the brake caliper to the brake caliper bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the brake caliper guide pin bolts (2).

    Tighten:  Tighten the bolts to 35 N.m (26 lb ft).

    3. Fig 2: View Of Front Brake Hose
    GM890982Courtesy of GENERAL MOTORS CORP.
  3. Remove the caps or plugs from the brake caliper opening and the brake hose.
    4. IMPORTANT: Do not reuse the copper brake hose gaskets.
  4. Install NEW copper brake hose gaskets (2) to the brake hose-to-caliper bolt (1) and to the brake hose (3).
  5. Install the brake hose and the brake hose-to-brake caliper bolt to the brake caliper.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  6. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure) or Hydraulic Brake System Bleeding (Manual) .
  7. Remove the wheel nuts retaining the brake rotor to the wheel hub.
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
  10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  11. Slowly release the brake pedal.
  12. Wait 15 seconds, then repeat steps 12 and 13 until a firm brake pedal apply is obtained; this will properly seat the brake caliper piston and brake pads.
scientia non olet · About LEMON Manuals