Sensing and Diagnostic Module Handling Caution
WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Be careful when you handle a sensing and diagnostic module (SDM). Do not strike or jolt the SDM. Before applying power to the SDM:
Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.
- Remove any dirt, grease, etc. from the mounting surface
- Position the SDM horizontally on the mounting surface
- Point the arrow on the SDM toward the front of the vehicle
- Tighten all of the SDM fasteners and SDM bracket fasteners to the specified torque value
Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.