Circuit/System Verification

Engine running, observe the scan tool MAF Sensor parameter. The reading should be between 1,700-3,800 Hz, depending on the engine coolant temperature (ECT).
A wide open throttle (WOT) acceleration from a stop should cause the MAF sensor parameter on the scan tool to increase rapidly. This increase should be from 2-6 g/s at idle to greater than 180 g/s at the time of the 1-2 shift.
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.