LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2010 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC P0567 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X204 harness connector at the turn signal/multifunction switch.
  2. Ignition ON, test for B+ between the B+ circuit terminal A8 and ground.
    • If less than the specified value, test the circuit for a short to ground or an open/high resistance.
  3. Verify the scan tool Cruise ON/OFF switch parameter displays OFF.
    • If not the specified value, test the signal circuit terminal B8 for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Install a 3A fused jumper wire between the signal circuit terminal B8 and the B+ circuit terminal A8. Verify the scan tool Cruise ON/OFF Switch parameter displays ON.
    • If not the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  5. If all circuits test normal, test or replace the turn signal/multifunction switch.
scientia non olet · About LEMON Manuals