Remote Control Door Lock Receiver Replacement (Copy and Paste TPM Information)
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
This procedure will learn the TPM information to the new RCDLR using the Copy and Paste function on the scan tool. This procedure will extract the TPM Tire Type information as well as the sensor data from the existing RCDLR prior to its replacement and store this information in the scan tool. After RCDLR replacement and SPS programming, the tire type and sensor data stored in the scan tool is written to the new RCDLR, negating the need to perform the tire type setup and sensor learn procedure.
This procedure should be considered as the first programming choice when replacing an RCDLR. The Copy and Paste procedure eliminates the possibility of incorrectly inputting the tire type or learning stray TPM sensors.
- Using a scan tool, navigate to the Copy and Paste TPM Information procedure and copy the existing TPM information from the RCDLR using the outline below. Follow the on-screen instructions after selecting Step 1:
- Vehicle Control Systems
- Module Setup
- Remote Control Door Lock Receiver
- Copy and Paste TPM Information
- Step 1
- At this point, install the new RCDLR.
- Program the RCDLR - Refer to Service Programming System (SPS) .
- Using a scan tool, navigate to the Copy and Paste TPM Information procedure to paste the stored TPM information using the outline below. Follow the on-screen instructions after selecting Step 2:
- Vehicle Control Systems
- Module Setup
- Remote Control Door Lock Receiver
- Copy and Paste TPM Information
- Step 2
- Program the keyless entry transmitters - Refer to Remote Control Door Lock Transmitter Programming .
IMPORTANT:
This step must be performed prior to the removal or replacement of the old RCDLR.