Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake pedal position sensor (3) to the vehicle.
- Install the brake pedal position sensor bolts (2) and tighten to 9 N.m (80 lb in).
- Connect the brake pedal position sensor electrical connector (1).
- Install the fuse block cover.
- Install the driver knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) , Knee Bolster Replacement (Cadillac) .
CAUTION:
Refer to Fastener Caution .