Wiper Switch

Wiper/washer switch is incorporated within multifunction switch, mounted on steering column. Test continuity of wiper switch circuits with switch in position indicated in table. See WIPER/WASHER SWITCH CONTINUITY TEST .
Ensure continuity exists between terminals listed. Check connector and terminal cavity identification. SeeFig 1 . For terminal descriptions, see MULTIFUNCTION SWITCH TERMINAL IDENTIFICATION .

Fig 1: Multifunction Switch Connector Terminal ID

Courtesy of HYUNDAI MOTOR CO.

WIPER/WASHER SWITCH CONTINUITY TEST ⁽¹⁾

Switch Position

Connector

Terminal Numbers

Off

"B"

19 & 21

Intermittent ⁽²⁾

"B"

19 & 21; 18, ⁽²⁾ 16 & 13

Low

"B"

16 & 21

High

"B"

16 & 20

Washer

"B"

16 & 17

⁽¹⁾	Continuity should exist between terminals listed.

⁽²⁾	A resistor in circuit should fluctuate resistance between terminals No. 16 and 13.