Component Tests: Sub-Switch
NOTE:
Sub-switch (SET/COAST and RESUME/ACCEL switch) is located in steering wheel and may be referred to as cruise remote control switch.
- Disconnect negative battery cable and wait at least 30 seconds before proceeding. Remove steering wheel. Locate 3-pin cruise control sub-switch connector M93 under steering wheel. See WIRING DIAGRAMS .
- Measure resistance between connector M93 terminals No. 1 (Light Blue wire) and No. 3 (Black/White wire). When SET/COAST switch is pressed, resistance should be about 220 ohms. Replace switch if resistance is not as specified.
- Measure resistance between connector M93 terminals No. 1 (Light Blue wire) and No. 3 (Black/White wire). When RESUME/ACCEL switch is pressed, resistance should be about 910 ohms. Replace switch if resistance is not as specified.