Anti-Lock Braking System Control Module: Installation
- Install the HECU, then connect the brake lines.
Tighten the HECU mounting bolts and brake tube nuts to the specified torque.
- Tightening torque
- HECU mounting bolt:
- 8-10 Nm (80-100 kg.cm, 6-7.3 lb.ft)
- Brake tube nut:
- 13-17 Nm (130-170 kg.cm, 10-12 lb.ft)
- Connect the HECU connector.
- Bleed the brake system.
- Start the engine, and check that the ABS indicator goes off.
- Test-drive the vehicle, and check that the ABS indicator does not come on.