Air Bag Control Module: Service and Repair

SRS UNIT REPLACEMENT

REMOVAL
1. Disconnect the battery negative cable, and wait at least three minutes before beginning work.
2. Disconnect the airbag connectors.
3. Disconnect the side airbag connectors.
4. Remove the center console.




5. Disconnect the connectors (A) from the SRS unit (B).




6. Remove the three bolts (A) from the SRS unit (B), than pull out the SRS unit from the bracket.

INSTALLATION
1. Install the new SRS unit with the three bolts, then connect the connectors to the SRS unit.
2. Install the center console.
3. Reconnect the airbag connectors.
4. Reconnect the side airbag connectors.
5. Reconnect the battery negative cable.
6. After installing the SRS unit, confirm proper system operation: Turn the ignition switch ON; the SRS indicator light should blink for about six seconds and then go off.