Front Hub/Knuckle: Reassembly

Apply a thin coat of multi-purpose grease to the knuckle and bearing contact surface.
Using the special tool (09216-21100), press-in the bearing to the knuckle.
NOTE:
- Do not press against the inner race of the wheel bearing because that can cause damage to the bearing assembly.
- Always use a new bearing assembly.
Fig 1: Pressing Bearing Into Knuckle Using Special Tool (09216-21100)
Courtesy of HYUNDAI MOTOR CO.
Install the snap ring into the groove of the knuckle.

Fig 2: Identifying Snap Ring
Courtesy of HYUNDAI MOTOR CO.
Using the special tool (09545-21100), press the hub on to the knuckle.
NOTE: Do not press against the outer race of the wheel bearing because that can cause damage to the bearing assembly.

Fig 3: Pressing Hub On To Knuckle
Courtesy of HYUNDAI MOTOR CO.
Tighten the hub to the knuckle to 200 Nm (20 kgf.m, 148 lb-ft) with the special tool (09517-21500).

Fig 4: Tightening Hub To Knuckle Using Special Tool (09517-21500)
Courtesy of HYUNDAI MOTOR CO.
Rotate the hub to seat the bearing.
Measure the wheel bearing starting torque.
Standard value

Starting torque: 1.8 Nm (0.18 kgf.m, 16 lb-ft) or less

Fig 5: Measuring Wheel Bearing Starting Torque
Courtesy of HYUNDAI MOTOR CO.
Fix a dial gauge and measure the hub end play. Check that it is within the standard value.
Standard value

Hub end play: 0.008 mm (0.0003 in) or less

Fig 6: Measuring Hub End Play
Courtesy of HYUNDAI MOTOR CO.
Remove the special tool.
Install the disc to the hub.