LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2009 >> Azera GLS >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Initiation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Tire Pressure Sensor Initiation

NOTE: In the following procedure, a TPMS exciter scan tool must be used.
NOTE: Do not perform this procedure if vehicle is parked on a metal floor, roof, or on an alignment rack or lift. The metal will transfer the RF signals, which can cause the learn procedure to fail and set Diagnostic Trouble Codes (DTCs).
  1. Holding TPMS exciter within 3" (76 mm) of the sensor valve, read each tire pressure sensor ID in the following order: front left, front right, rear left, then rear right.
  2. Connect TPMS exciter to Data Link Connector (DLC) located under left side of instrument panel. Register the 4 sensor IDs to receiver. See Fig 1 and Fig 2 .
  3. Disconnect TPMS exciter from diagnostic link. Cycle ignition and wait 4 minutes. Ensure "NORMAL RECEIVER STATE" is now displayed.
Fig 1: Registering Tire Pressure Sensor (1 Of 2)
G00251654Courtesy of HYUNDAI MOTOR CO.
Fig 2: Registering Tire Pressure Sensor (2 Of 2)
G00251655Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About LEMON Manuals