Monitor Scan Tool Data

[2.0] 

1. Check transponder and ECU status
   1. IGN "ON" & Engine "OFF"
   2. Monitor the "ECU, KEY and Smartra STATUS" Parameter on the Scan tool.

      Specification: 'LEARNT'

      Fig 1: Monitoring ECU, KEY And Smartra Status Parameter

      Courtesy of HYUNDAI MOTOR CO.

      Fig 1) This data show that 3 keys have been taught, ECU has been learnt, Key in key cylinder has been learnt and SMARTRA3 has been learnt.

   3. Have both the ECM and KEY status been learnt?

      YES 

      • Check connectors for looseness, poor connection, bending, corrosion, contamination deterioration, damage on the ECM or SMARTRA.

        And this DTC has not been erased in previous repair. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      • Go to "COMPONENT INSPECTION " Procedure.